We have 7 fully stocked warehouse and showroom locations for pickup and orders by phone and email.
|
Corporate Office 131-02 Jamaica Avenue Richmond Hill, NY 11418 TEL: (718) 847-3400 FAX: (718) 805-9816 |
Wingdale Office 2108 Route 22 Wingdale, NY 12594 TEL: (845) 832-0100 FAX: (845) 832-0300 |
Medford Office 2058 Horse Block Road Medford, NY 11763 TEL: (631) 698-3000 FAX: (631) 698-3142 |
|
Garfield Office 112 Monroe Street Garfield, NJ 07026 TEL: (973) 472-5121 FAX: (973) 472-9260 |
Blackwood Office 560 South Black Horsepike Blackwood, NJ 08012 TEL: (856) 374-3004 FAX: (856) 374-3006 |
New England Office 40 Locke Drive Marlborough, MA, 01752 Phone 508-251-2820 Fax 508-251-1794 |
|
New location: Boundary Fence of Rochester 595 Trabold Rd. Rochester, NY 14624 TEL: 585-270-5090 FAX: 585-270-5132 |
||
| FLEXIBLE BAMBOO SCREEN | |
| PART # | SIZES (FT) |
| 3/8"Dia - 4' h | 4'x15' (made of 3/8" approximate diameter whole bamboo) |
| 3/8"Dia - 5' h | 5'x15' (made of 3/8" approximate diameter whole bamboo) |
| 3/8"Dia - 6' h | 6'x15' (made of 3/8" approximate diameter whole bamboo) |
| 4'h x 15' Roll | Split Reed Bamboo fence |
| 5'h x 15' Roll | Split Reed Bamboo fence |
| 6'h x 15' Roll | Split Reed Bamboo fence |
| 5' h x 10'long | Brushwood Bamboo Fence |
![]() |
|
| FLANGE FOR BAMBOO POST | |
![]() |
Specifically designed for bamboo installation. Bottom plate is 5” X 5” X 1/4” holding plates are 10 Gauge X 6” high |
| Use 4 #10 Stainless screws X 3 1/2” and 4 sleeve anchors 3/8” X 3” (sold separately for prices see page G15) | |
| FLOOR FLANGE Used for above ground installation | |
| IN GROUND FLOOR FLANGE In the ground installation same as above less the sleeve anchors pipe goes in the ground 24” | |
| # 10 Stainless screws Square Driver Bid | |
BAMBOO INSTALLATION
Each post id shaped according to its use. Before installing, lay down the post on the floor. Each post is grooved & pinned to receive the panel. End post have one groove, Line post have two grooves opposite to each other, Corner post have two grooves 90o from each other, Gate posts could have one groove, when used without any connecting panels, or two grooves if used in line. Flanges are used for mounting the post. For hard surface a flat flange is provided. For soil installation the flange has 2 ft extension which goes in cement. Flanges are coated beige to match bamboo.
Each bamboo post has a steel insert 20” up from the bottom of the post for added strength. Pins stick out of the groove to match the panel.
3) Connect panel to post by matching the holes in the section with the pins on the post, drill pilot hole with drill bit (do not use stainless steel screws without the pilot hole, bamboo will split). Insert the #10 X 3 1/2” stainless steel flat head screw.
FINISH
Each component has been factory coated with 3 coats of outdoor varnish with UV protection. If you want to retain the original shine a coat of varnish with UV protection should be applied after installation and once a year thereafter. If not coated the bamboo will turn into beautiful silver gray color pleasant and natural to eyes. If used indoor coat when desired.
WOOD POST & RAIL SYSTEM



